plasterer

A re-skim of some old walls in Co Dublin, The walls were thistlebonded and skimmed the next day There was also some patching to be done in the hallway where previous builders had left some walls rough

This Extension in Enfield included plasterer boarding and Skimming on interior using 55 mm insulated board on the inside of the exterior walls. The outside is finished in a sand and cement nap finish.

This protect consisted of sand and cement sponge finish over block on the outside and Plaster-boarding, slabbing and skimming on the inside. The outside was first scudded at a mix of sand,lime and cement 1;1 before it was scratched with a mix at 3;1. The final cot was mixed at 4;1 and finished with a […]

First the top ceilings of the house were plaster-boarded with 70 mm insulated thermal plasterboard’s before we then plaster-boarded all the partitions.It was decided to use hard-coat on all block walls instead of sand and cement to allow for superior drying. The house is airtight with membrane on all ceilings upstairs and around all windows […]

This house was completed interior and exterior. The outside was Plastered in sand and cement with a sponge finish to allow finishing with Acrylic and the internal was dry-lined, Floated and skimmed.InteriorThe interior plastering was completed over the course of four weeks,I dry-lined the upstairs and downstairs ceilings with half inch plasterboard. All block walls […]

This 20 meter square extension was to be boarded, rendered and skimmed on the inside with some patchwork to be completed on other parts of the house, The outside was scudded, scratched, dry dashed finished with bands with a sponge finish.

This was a small reskim of Two rooms in Dunboyne Co. Meath. We started by scraping back the stipple on the ceiling which was fairly uneven, brushing it when finished as to remove any loose particles. The walls and ceilings wher then thistle bonded and left to dry over night to dry leaving the rooms […]

This project involved Sticking plasterboard onto existing brick walls, Sticking involves scabbing large blobs of plasterer onto the walls, then placing the plasterboard against these blobs using a strait edge and level to tap the plasterboard until the wall is strait and plumb.The walls were quiet old so had to be cleaned and treated before […]

We began this project by scudding the entire house in a scud coat of around 1/1 sand and cement. We then scratch coated the house with a mix of 3:1:1/2 sand/cement and lime adding water proofer as needed.  The bands on this project were a little awkward due to the windows on the new part […]